Powerful whitelight RGB laser device...
Availability date: 01/01/1970
The Laserworld CS-2000RGB is a RGB laser system with a total output power of up to 2,000mW.
The red diode laser module with a wavelength of 650nm, the green DPSS laser module with a wavelength of 532nm and the royal-blue diode laser module with a wavelength of 445nm ensure brilliant colors and powerful laser beams. The projector has good beam specifications with a beam diameter of about 3mm and beam divergence of 2.0mrad. At the same time it offers a galvo system with up to 30kpps as well as a scan angle of up to 40°. The Laserworld CS-2000RGB has a professional ILDA interface. Thus own or pre-programmed lasershows can be shown by use of a laser control software, e.g. of Phoenix or Pangolin. Through DMX about 200 preset patterns, like waves, tunnels, circles etc. can be projected in different colors and in a various speed. The laser system has an automatic mode, which runs the pre-programmed patterns without assistance. If the music mode is active, the laser system projects according to the sound. For the music mode the sensitivity of the mircophone can easily be set on the rear side of the projector. There is a key switch, an interlock interface and an on-off switch at the rear side of the device.
The Laserworld CS-2000RGB is a powerful whitelight laser systems. This device is well suited for professional applications and it is often used in medium to larger sized clubs and discos as well as for the use in any party location.
|power red:||>500mW / 650nm|
|power green:||>200mW / 532nm|
|power blue:||>800mW / 445nm|
|beam specifications:||ca. 3mm / 2mrad|
|laser source:||Diode, DPSS Laser|
|operation modes:||auto, music, DMX, ILDA|
|scanner:||galvo system, 30kpps @4°|
|scan angle:||40° max.|
|basic patterns:||ca. 200 (layers, tunnels, fences, waves, ect.)|
|accessories:||power cable, manual, interlock connector, key|
|power supply:||85V - 250V AC|
|power consumption:||50 W|
*Warning: every device that includes a laser diode, needs to be shut down for at least 10 minutes for every 2 hours. In case of not following the given instructions, the laser diode may burn out and won't be accepted as a reason for warranty.